PEUGEOT 2008 Handbook page 145

F Screw the pipe onto the valve and tighten
firmly.
F Check that the compressor switch is in the
"O" position.
F Fully uncoil the electric cable, stowed under
the compressor.
F Connect the compressor's electric plug to
the vehicle's 12 V socket.
F Switch on the ignition.
The tyre inflation pressures are given on
this label.
F Start the compressor by placing the switch
in the "I" position and adjust the pressure
to the value shown on the vehicle's tyre
pressure label. To deflate: press the black
button located on the compressor pipe, near
the valve connection.
If a pressure of 2 bars is not reached after
7 minutes, this indicates that the tyre is not
repairable; contact a PEUGEOT dealer or
a qualified workshop for assistance.
F Once the correct pressure is reached, put
the switch in the "O" position.
F Remove the kit then stow it.
In the event of a breakdown
Do not drive more than 125 mph
(200 km/h) with the repaired tyre; see a
PEUGEOT dealer or a qualified workshop
to change the tyre.
Tyre under-inflation detection
After a tyre repair, this warning
lamp will remain on until the
system is reinitialised.
For more information on Under-inflation
detection, refer to the corresponding
section.
Should the pressure of one or more tyres
be adjusted, it is necessary to reinitialise
the under-inflation detection system.
For more information on Under-inflation
detection, refer to the corresponding
section.
8
143