PEUGEOT 2008 Handbook page 111

Programming
F Turn the dial 1 to the "LIMIT" position:
speed limiter mode is selected but is not
switched on (II).
You do not have to switch the speed limiter on
in order to set the speed.
F Set the speed value by pressing button 2
or 3.
You can then change the programmed speed
using buttons 2 and 3:
- by + or - 1 mph (1 km/h) = short press,
- by + or - 5 mph (5 km/h) = long press,
- in steps of + or - 5 mph (5 km/h) =
maintained press.
F Switch the speed limiter on by pressing
button 4.
F Switch the speed limiter off by pressing
button 4: the display confirms that it has
been switched off (II).
F Switch the speed limiter back on by
pressing button 4 again.
Exceeding the programmed
speed
Pressing the accelerator pedal in order to
exceed the programmed speed will have
no effect unless you press the pedal firmly
beyond the point of resistance.
The speed limiter is deactivated temporarily
and the programmed speed, which is still
displayed, flashes.
Returning to the programmed speed, by means
of intentional or unintentional deceleration of
the vehicle, automatically cancels the flashing
of the programmed speed.
Exiting speed limiter mode
F Turn the dial 1 to the 0 position: the speed
limiter mode is deselected. The display
returns to the total mileage recorder.
Malfunction
In the event of a speed limiter fault, the speed
is cleared resulting in flashing of the dashes.
Have it checked by a PEUGEOT dealer or a
qualified workshop.
On a steep descent or in the event of
sharp acceleration, the speed limiter will
not be able to prevent the vehicle from
exceeding the programmed speed.
To avoid any risk of jamming of the pedals:
- ensure that the mat is positioned
correctly,
- never place one mat on top of another.
Driving
6
109