Set Voltage Limit - Keithley 2520 User Manual

Model 2520 User's Manual
Query
Description
NOTE

Set voltage limit

PROTection[:LEVel] <NRf>
:SOURce[1]:VOLTage:PROTection[:LEVel] <NRf>
Parameters
Query
Description
Select source polarity
POLarity <name>
[:SOURce[1]]:CURRent:POLarity <name>
Parameters
Query
Description
:LOW?
:LOW? DEFault
:LOW? MINimum
:LOW? MAXimum
This command is used to set the pulse low amplitude level for all current
source pulses. For the 500mA source range, the low value can be set
from 0 to 0.015A. For the 5A source range, the low value can be set
from 0 to 0.150A.
This command sets the pulse low amplitude for the pulse source function in the
list and sweep modes. See
source function," page
<NRf> = 3 to 10.5
:PROTection?
This command is used to the set the voltage protection limit, which
clamps the current source output voltage at the programmed limit. See
Section 5, "Current source operating
<name> = POSitive
NEGative
:POLarity?
This command is used to select the polarity for the laser diode current
source. POSitive selects normal polarity, while NEGative selects
reversed polarity.
See Section 3,
polarity.
Query programmed low amplitude
Query *RST default low amplitude
Query lowest allowable low amplitude
Query highest allowable low amplitude
"Select sourcing mode," page
14-33.
Set voltage compliance limit
Set voltage compliance limit
Query programmed voltage limit
boundaries," for more information.
Set laser diode current source polarity
Positive polarity
Negative polarity
Query measurement polarity
"Configuring measurements," for more information on
SCPI Command Reference
14-32, and
14-35
"Select