Reassembling The Fpd - Agilent Technologies 7820A Service Manual

Gas chromatograph

Hide thumbs Also See for 7820A:

Table of Contents

Agilent 7820 GC Service

Reassembling the FPD

This part of the procedure reassembles the optics assembly with

the transfer line, reconnects both to the detector bracket,

replaces the heater/sensor and ignitor wires, replaces the covers

1 Replace or install the O-ring on the transfer line jet. Remove

the O-ring with a small pick. Place the new O-ring over the

jet. Roll it into the groove below the jet.