Command/Response Table for Basic MVC 121 Plus SIS Commands
Command
NOTE: Commands can be entered back-to-back in a string, with no spaces.
Upper and lower case may be used interchangeably.
General Commands
Firmware Version, Part Number, and Model Information
Query firmware version
Query firmware and build
version
Query part number
Query model name
Query model description
Setup Commands
Set verbose mode
View verbose mode
Key:
X#
=
On/Off
X1#
=
Version number
X1$
=
Version and Build number
X2$
Verbose/Response mode
Bi-directional Serial Data Port
NOTE: CP and CV commands apply to both RS-232 and USB ports.
Configure parameters
View parameters
ZAP Commands (Factory Defaults) and RAM Commands
System reset (factory
default)
Absolute system reset
View internal temperature
status in degrees Celsius
Key:
X2@
=
Internal temperature
X3$
=
Baud rate
ASCII Command
(Host to Tuner)
Q
*Q
N
1I
2I
E X2$
}
CV
E
CV
}
0 = off/mute
Listed to two decimal places (for example, x.xx)
The least significant bits is the build number (for example, x.xx.xxxx)
0 = Tag OFF, Broadcast OFF (no tag in GET command response, always tag in SET command response)
1 = Tag OFF, Broadcast ON (not tagged, broadcast)
2 = Tag ON, Broadcast OFF
3 = Tag ON, Broadcast ON
Default = 1
NOTE:
If 'tagged responses' is enabled, all read commands will return the constant string + the data,
similar to setting the value, for example, command:
E X3$
}
CP
E
CP
}
E
}
ZXXX
E
}
ZQQQ
20S
Degrees Celsius
0 = 9600
1 = 19200
Response
(Tuner to Host)
Example: TvprS25*11•3
X1# ]
X1$ ]
60-1096-01
]
]
MVC • 121 • Plus
]
Mixer
Volume
Controller
•
•
X2$ ]
Vrb
X# ]
1 = on/unmute
E
X3$ ]
Ccp
Ccp
X3$ ]
]
Zpx
]
Zpq
X2@ ]
Sts20*
2 = 38400 (default)
MVC 121 Plus • SIS Programming and Control
Additional Description
Show the current firmware version.
Show the current firmware and build
version.
Show the unit part number.
Show the model name.
Set verbose/response mode.
View verbose mode
}
X1@]
response: Ipn•
CN
Set baud rate:
0 = 9600
1 = 19200
2 = 38400 (default)
3 = 115200
View baud rate.
Reset system to factory default
except for the baud rate.
Similar to system reset, plus sets
the baud rate to factory default.
View internal temperature in
degrees Celsius.
3 = 115200
32
Need help?
Do you have a question about the MVC 121 Plus and is the answer not in the manual?