Table of Contents
Advertisement
Home >
Troubleshooting
Error and Maintenance Messages
•
HL-3190CDW
If the LCD displays errors and your Android
NFC symbol on your Brother machine to access the Brother Solutions Center and browse the latest
FAQs from your device. (Your mobile telephone provider's message and data rates may apply.)
Make sure the NFC settings of both your Brother machine and your Android
As with any sophisticated office product, errors may occur and supply items may have to be replaced. If this
happens, your machine identifies the error or required routine maintenance and shows the appropriate message.
The most common error and maintenance messages are shown in the table.
Follow the instructions in the Action column to solve the error and remove the message.
You can correct most errors and perform routine maintenance by yourself. If you need more tips: Visit
support.brother.com, and click the FAQs & Troubleshooting page.
HL-3160CDW
Error Message
2-sided Disabled
Access Denied
Belt End Soon
Calibrate
Cartridge Error
Condensation
Cooling Down
> Error and Maintenance Messages
Cause
The back cover of the machine is
not closed completely.
The function you want to use is
restricted by Secure Function
Lock 3.0.
The belt unit is near the end of its
life.
Calibration failed.
The toner cartridge is not installed
correctly.
Condensation may have formed
inside the machine after a room
temperature change.
The temperature of the inside of
the machine is too hot. The
machine pauses its current print
job and goes into cooling down
mode.
™
device supports the NFC feature, touch your device to the
Action
Close the back cover of the machine until it
locks in the closed position.
Ask your administrator to check your Secure
Function Lock Settings.
Order a new belt unit before the LCD displays
Replace Belt.
•
Press and hold down
machine off. Wait a few seconds, and then
turn it on again. Perform the colour
calibration again using the control panel.
•
Install a new belt unit.
•
If the problem continues, contact Brother
customer service or your local Brother
dealer.
Remove the toner cartridge and drum unit
assembly for the colour that is indicated on the
LCD. Take out the toner cartridge, and put it
back into the drum unit again. Re-install the
toner cartridge and drum unit assembly back
in the machine.
If the problem continues, contact Brother
customer service or your local Brother dealer.
Leave the machine turned on. Wait for 30
minutes with the top cover in the open
position. Then turn off the machine and close
the cover. Turn it on again.
Wait until the machine has finished cooling
down. Make sure all vents on the machine are
clear of obstructions.
When the machine has cooled down, it will
resume printing.
™
device are set to On.
to turn the
182
Advertisement
Table of Contents
