Table of Contents
Advertisement
Error Messages
Server Timeout, contact your
administrator.
Wrong Date&Time, contact
your administrator.
HL-3190CDW
Error Messages
A device is
already
connected. Press
[OK].
Authentication
error, contact
your
administrator.
Connection Error
Connection Failed The Brother machine and your
File access
error, contact
your
administrator.
Log Access Error
No Device
Cause
The Brother machine cannot connect
to the server for the Store Print Log to
Network feature.
The Brother machine does not obtain
the time from the SNTP time server.
Cause
The maximum number of mobile
devices are already connected
to the Wi-Fi Direct network when
the Brother machine is the
Group Owner (G/O).
Your authentication setting for
the Store Print Log to Network
feature is not correct.
Other devices are trying to
connect to the Wi-Fi Direct
network at the same time.
mobile device cannot
communicate during the Wi-Fi
Direct network configuration.
The Brother machine cannot
access the destination folder for
the Store Print Log to Network
feature.
In Web Based Management,
you have selected the Cancel
Print option in the Error
Detection Setting of Store
Print Log to Network.
When configuring the Wi-Fi
Direct network, the Brother
machine cannot find your mobile
device.
Action
device has been configured via
DHCP.
•
Make sure your server address is
correct.
•
Make sure your server is
connected to the network.
•
Make sure the machine is
connected to the network.
•
Make sure the settings to access
the SNTP time server are
configured correctly in Web Based
Management.
Action
After the current connection between your Brother
machine and another mobile device has shut down, try to
configure the Wi-Fi Direct settings again. You can confirm
the connection status by printing the Network
Configuration Report.
•
Make sure the Username and Password in
Authentication Setting are correct. If the username
is part of a domain, enter the username in one of the
following styles: user@domain or domain\user.
•
Make sure the SNTP time server settings are
configured correctly so the time matches the time
used for authentication by Kerberos or NTLMv2.
Make sure there are no other devices trying to connect to
the Wi-Fi Direct network, and then try to configure the Wi-
Fi Direct settings again.
•
Move the mobile device closer to your Brother
machine.
•
Move your Brother machine and the mobile device to
an obstruction-free area.
•
If you are using the PIN Method of WPS, make sure
you have entered the correct PIN.
•
Make sure the stored directory name is correct.
•
Make sure the stored directory is write-enabled.
•
Make sure the file is not locked.
Wait for about 60 seconds until this message disappears
from the LCD.
•
Make sure your machine and mobile device are in the
Wi-Fi Direct mode.
•
Move the mobile device closer to your Brother
machine.
•
Move your Brother machine and the mobile device to
an obstruction-free area.
•
If you are manually configuring the Wi-Fi Direct
network, make sure you have entered the correct
password.
211
Advertisement
Table of Contents
