Table of Contents
Advertisement
Error Message
Replace WT Box
Self-Diagnostic
Short paper
Size Error
Size Error DX
Size Mismatch
Toner Error
Toner Low: BK
Toner Low: C
Toner Low: M
Toner Low: Y
(BK=Black, C=Cyan,
M=Magenta, Y=Yellow.)
WT Box End Soon
HL-3190CDW
Error Message
2-sided Disabled
Access Denied
Calibration
Cause
It is time to replace the waste
toner box.
The temperature of the fuser unit
does not rise to a specified
temperature within the specified
time.
The fuser unit is too hot.
The length of the paper in the tray
is too short for the machine to
deliver it to the Face down output
tray.
The paper size defined in the
printer driver is not supported by
the defined tray.
The paper size specified in the
machine's paper size setting is not
available for automatic 2-sided
printing.
The paper in the tray is not the
correct size and is not available
for automatic 2-sided printing.
The paper in the tray is not the
correct size.
One or more toner cartridges are
not installed or not installed
correctly.
If the LCD displays this message,
you can still print. The toner
cartridge is near the end of its life.
The waste toner box is almost full. Order a new waste toner box before the LCD
Cause
The back cover of the machine is
not closed completely.
The function you want to use is
restricted by Secure Function
Lock 3.0.
Calibration failed.
Action
Replace the waste toner box with a new one.
See Related Information: Replace the Waste
Toner Box.
Press and hold
to turn the machine off,
wait a few seconds, and then turn it on again.
Leave the machine idle for 15 minutes with the
power on.
Open the back cover (Face up output tray) to
let the printed page exit onto the Face up
output tray. Remove the printed pages, and
then press Go.
Choose a paper size supported by the defined
tray.
Press Cancel (if required).
Load the correct size of paper in the tray and
set the tray for that paper size.
Choose a paper size supported by 2-sided
printing.
Paper size available for automatic 2-sided
printing is A4.
Load the correct size of paper in the tray and
set the size of paper for the tray. Press Go.
Pull out the drum units. Remove all the toner
cartridges, and then put them back into the
drum units.
Order a new toner cartridge before the LCD
displays Replace Toner.
displays Replace WT Box.
Action
Close the back cover of the machine until it
locks in the closed position.
Ask your administrator to check your Secure
Function Lock Settings.
•
Press and hold down
machine off. Wait a few seconds, and then
turn it on again. Perform the colour
calibration again using the LCD.
•
Install a new belt unit.
•
If the problem continues, contact Brother
customer service or your local Brother
dealer.
to turn the
185
Advertisement
Table of Contents
