Table of Contents
Advertisement
Level 1
Level 2
WLAN
MAC Address
Set to Default -
WLAN Enable
Wi-Fi Direct Push Button
PIN Code
Manual
Group Owner
Device Info.
Status Info.
I/F Enable
Network
-
Reset
1
On connection to the network, if the machine's 'Boot Method' is 'Auto' the machine will attempt to set the IP address and Subnet Mask
from a boot server such as DHCP. If a boot server cannot be found, an APIPA IP address will be allocated, such as 169. 254. [001-254].
[000-255]. If the 'Boot Method' of the machine is set to 'Static', you must manually enter an IP address from the machine's control panel.
[Print Reports]
Level 1
Level 2 Description
Printer Settings -
Network Config
-
Print File List
-
Drum Dot Print
-
WLAN Report
-
[Machine Info.]
Level 1
Level 2
Serial No.
-
Firmware Version -
Page Counter
-
Toner
1
Parts Life
Drum
Level 3
Level 4
-
-
-
-
-
-
-
-
-
-
-
-
-
Device Name -
SSID
-
IP Address
-
Status
-
Signal
-
Channel
-
Speed
-
-
-
-
-
Print the Printer Settings page.
Print the Network Configuration Report.
Print a list of data saved in the memory.
Print the Drum Dot Check Sheet.
Print the wireless LAN connectivity diagnosis result.
Description
Display the machine's serial number.
Check your machine's firmware version.
Display the total printed pages.
Display the remaining life of each toner.
Display the remaining life of each drum unit.
Descriptions
Display the MAC address of the machine.
Restore wireless network settings of your
machine to the factory settings.
Turn the wireless interface on or off.
Configure your Wi-Fi Direct network settings
using the one-button push method quickly.
Configure your Wi-Fi Direct network settings
using WPS with a PIN code quickly.
Configure your Wi-Fi Direct network settings
manually.
Set your machine as the Group Owner.
View your machine's device name.
Display the Group Owner's SSID.
Display your machine's IP Address.
Display the Wi-Fi Direct network status.
Display the current Wi-Fi Direct network signal
strength.
When your machine acts as Group Owner, the
LCD always displays Strong.
Display the channel in use when the Status is
G/O Active or Client Active.
Display the connection speed when the Status
is G/O Active or Client Active.
Enable or disable the Wi-Fi Direct connection.
Restore all network settings of your machine to
the factory settings.
290
Advertisement
Table of Contents
