Table of Contents
Advertisement
Level 1
Level 2
Wired LAN
TCP/IP
Ethernet
Wired Status
MAC Address
Set to Default -
Wired Enable
WLAN
TCP/IP
Setup Wizard
WLAN Assistant -
WPS
WPS w/PIN Code -
WLAN Status
Level 3
Level 4
DNS Server
Primary
Secondary Specify the IP address of the secondary DNS
APIPA
-
IPv6
-
-
-
-
-
-
-
-
-
-
Boot Method -
IP Address
-
Subnet Mask -
Gateway
-
Node Name
-
WINS Config -
WINS Server Primary
Secondary Specify the IP address of the secondary WINS
DNS Server
Primary
Secondary Specify the IP address of the secondary DNS
APIPA
-
IPv6
-
-
-
-
-
-
-
Status
-
Signal
-
Channel
-
Speed
-
SSID
-
Comm. Mode
-
Descriptions
Specify the IP address of the primary DNS
server.
server.
Allocate the IP address from the link-local
address range automatically
Turn the IPv6 protocol on or off.
Choose the Ethernet link mode.
Display the Ethernet link status.
Display the MAC address of the machine.
Restore wired network settings of your machine
to the factory settings.
Turn the wired interface on or off.
Choose the IP method that best suits your
needs.
Enter the IP address.
Enter the Subnet mask.
Enter the Gateway address.
Enter the Node name.
Select the WINS configuration mode.
Specify the IP address of the primary WINS
server.
server.
Specify the IP address of the primary DNS
server.
server.
Allocate the IP address from the link-local
address range automatically
Turn the IPv6 protocol on or off.
Configure the wireless network settings using
the setup wizard.
Configure your wireless network settings using
the Brother installation disc.
Configure your wireless network settings using
the one-button push method.
Configure the wireless network settings using
WPS with a PIN code.
Display the wireless Ethernet link status.
Display the signal condition.
Display the channel in use when Status is
Active.
Display the connection speed when Status is
Active.
Display SSID.
Display the current Communication mode.
1
.
1
.
289
Advertisement
Table of Contents
