Table of Contents
Advertisement
•
Windows 8
Move your mouse to the lower right corner of your desktop. When the menu bar appears, click Settings >
Control Panel > Hardware and Sound > Devices and Printers > Add a device.
•
Windows 10
Click
> Windows System > Control Panel. In the Hardware and Sound group, click Add a device.
•
To use a Windows 7, Windows 8, or Windows 10 computer as a Registrar, you must register it to your
network in advance. For more information, see the instructions supplied with your wireless LAN access
point/router.
•
If you use Windows 7, Windows 8, or Windows 10 as a Registrar, you can install the printer driver after
the wireless configuration by following the on-screen instructions. To install the Full Driver & Software
Package necessary for operating your machine, insert the Brother installation disc into your computer
or go to your model's Downloads page on the Brother Solutions Center at support.brother.com.
9. Select your machine and click Next.
10. Type the PIN displayed on the machine's LCD, and then click Next.
11. (Windows 7) Select your network, and then click Next.
12. Click Close.
If your wireless device is connected successfully, the machine's LCD displays [Connected].
You have completed the wireless network setup. To install the Full Driver & Software Package necessary for
operating your machine, insert the Brother installation disc into your computer, or go to your model's Downloads
page on the Brother Solutions Center at support.brother.com.
HL-3190CDW
1. Press
[Settings] > [All Settings] > [Network] > [WLAN] > [WPS w/ PIN Code].
2. When [Enable WLAN?] appears, press [Yes].
This will start the wireless setup wizard. To cancel, press [No].
3. The LCD displays an eight-digit PIN and the machine starts searching for a wireless LAN access point/router.
4. Using a computer connected to the network, in your browser's address bar, type the IP address of the device
you are using as the Registrar. (For example: http://192.168.1.2)
5. Go to the WPS settings page and type the PIN, and then follow the on-screen instructions.
•
The Registrar is usually the wireless LAN access point/router.
•
The settings page will differ depending on the brand of wireless LAN access point/router. For more
information, see the instructions supplied with your wireless LAN access point/router.
If you are using a Windows 7, Windows 8, or Windows 10 computer as a Registrar, complete the
following steps:
6. Do one of the following:
•
Windows 7
Click
(Start) > Devices and Printers > Add a device.
•
Windows 8
Move your mouse to the lower right corner of your desktop. When the menu bar appears, click Settings >
Control Panel > Hardware and Sound > Devices and Printers > Add a device.
•
Windows 10
Click
> Windows System > Control Panel. In the Hardware and Sound group, click Add a device.
79
Advertisement
Table of Contents
