Table of Contents
Advertisement
Error Message
No Paper T1
No Toner
No Tray T1
No Waste Toner
Out of Memory
Print Data Full
Print Unable ##
Registration
Replace Belt
Replace Drum
Replace Toner
Cause
The machine failed to feed paper
from the indicated paper tray.
The toner cartridge is not installed
or not installed correctly.
The paper tray is not installed or
not installed correctly.
The waste toner box is not
installed or not installed correctly.
The machine's memory is full.
The machine's memory is full.
The machine has a mechanical
problem.
Registration failed.
It is time to replace the belt unit.
It is time to replace the drum unit.
If this message is displayed even
after replacing the drum unit with
new one, the drum unit counter
was not reset.
The toner cartridge is at the end of
its life. The machine stops all print
operations.
Action
Do one of the following:
•
Refill paper in the paper tray indicated on
the LCD. Make sure the paper guides are
set to the correct size.
•
If paper is in the tray, remove it and load it
again. Make sure the paper guides are set
to the correct size.
•
Do not overfill the paper tray.
Remove the toner cartridge and drum unit
assembly. Remove the toner cartridge from the
drum unit, and reinstall the toner cartridge
back into the drum unit. Reinstall the toner
cartridge and drum unit assembly back in the
machine. If the problem continues, replace the
toner cartridge.
Reinstall the paper tray indicated on the LCD.
Reinstall the waste toner box.
Press and hold Go for about two seconds and
reduce the print resolution.
Press Cancel and delete the previously stored
secure print data.
•
Press and hold
to turn the machine off,
wait a few minutes, and then turn it on
again.
•
If the problem continues, contact Brother
customer service.
•
If the error continues, press and hold down
to turn the machine off.
Wait a few seconds, and then turn on the
machine again.
Perform the colour registration using the
control panel.
•
Install a new belt unit.
•
If the problem continues, contact Brother
customer service or your local Brother
dealer.
Replace the belt unit with a new one.
See Related Information: Replace the Belt
Unit.
Replace the drum unit for the colour indicated
on the LCD.
See Related Information: Replace the Drum
Unit.
Reset the drum unit counter.
See Related Information: Replace the Drum
Unit.
Replace the toner cartridge for the colour
indicated on the LCD.
See Related Information: Replace the Toner
Cartridge.
184
Advertisement
Table of Contents
