GE Druck ADTS 405 R/F Mk2 Instruction Manual page 44

Chapter 3. OPERATION
Constant
indication
of values
Current
changing
parameter
Aim (set-point or target)
or "leak-measure" when
controller selected off
Rate Timer Displays (Fig 3.5 and Fig 3.6)
When in Leak Measure mode and, after completing a rate timing, the system generates the rate
timer displays. These displays are independent of the display mode (single, dual, triple or option).
Note: There is no pointer for the primary parameter, values cannot be entered
in the rate timer displays.
Pressing a parameter key (ALT, ROC, etc) or CLEAR/QUIT exits the rate timer displays.
Parameters
Measured
26 | ADTS 405 Mk2 Instruction Manual-English
Figure 3-4: Triple Display
Measured values
Alt 10000
CAS 582.0
ROC 2995
Aim 3000
Pointer for primary
parameter - aim that
changes on data entry
Timed
values
ROC -17.25 T
Rt CAS
-0.52 T
Timed Rates
Figure 3-5: Rate Timer Display Aeronautical Units
T for timed rate
of change
ft
kts
ft/min
Special
message
T for timed rate
of change
ft/m
Kts/m
Units of
Special
message measurement
© 2015 General Electric Company – All rights reserved.
Units of
measurement