GE Druck ADTS 405 R/F Mk2 Instruction Manual page 45

Pt Only Display (Fig 3.7)
The Pt only display overrides the other display modes (single, dual and triple). The measured
altitude and the CAS are produced from Ps in measure mode.
Alt always
shown
Selected
parameter
Aim (set-point or target)
or "leak-measure" if
Pitot controller selected off
3.5.1.1 Change display units:
a. Press SETUP.
b. Select [MORE].
c. Select [DISPLAYS/OPTIONS].
d. Select [DISPLAY TYPE].
e. Using [NEXT] or [PREV].
f. Select either SINGLE, DUAL or TRIPLE, ENCODER (more display types with options fitted).
g. Press [SAVE] to accept.
h. Press CLEAR/QUIT repeatedly to return to user display.
© 2015 General Electric Company – All rights reserved.
Parameters Timed
Measured values
Rt Ps
0.637 T
Rt Pt
0.341 T
Rt Qc
-0.224 T
Timed Rates
Figure 3-6: Rate Timer Display Pressure Units
Measured
altitude
Alt 407
Pt Only
CAS 0.0
Aim
0.0
Pointer for
parameter
Figure 3-7: Pt Only Display
T for timed rate
of change
mbar/m
mbar/m
mbar/m
Units of
Special
message
measurement
T for timed rate
of change
ft
kts
Special
messages
ADTS 405 Mk2 Instruction Manual-English | 27
Operating Procedures