GE Druck ADTS 405 R/F Mk2 Instruction Manual page 43

The triple display always shows altitude and airspeed; with pressure units selected, the display
always shows Ps and either Qc, Pt or EPR. When ALT or CAS are selected the display shows the aim
and measured values of ALT and CAS as a dual display. With any other selected parameter the
display shows the measured values of altitude and airspeed and, the aim and measured value of the
other selected parameter. Additional display modes are available for certain options.
Note: The ADTS 405 automatically returns to the pressure display if left
inactive in any set-up or menu type display for a period of more than one
minute.
Controlled
or measured
parameter
Controlled
or measured
parameters
Aim (set-point or target)
or "leak-measure" when
controller selected off
© 2015 General Electric Company – All rights reserved.
T for timed rate
Measured value
of change
Alt 10000
10000
Aim
Aim (set-point or target)
or "leak-measure" when
controller selected off
Figure 3-2: Single Display
Measured values
Alt 10000
Aim 10000
CAS 582.0
Aim 600.0
Pointer for primary
parameter - aim that
changes on data entry
Figure 3-3: Dual Display
Units of
measurement
ft
WARMUP
Pointer for Special
parameter messages
T for timed rate
of change
ft
kts
Special
message
Operating Procedures
Units of
measurement
ADTS 405 Mk2 Instruction Manual-English | 25