GE Druck ADTS 405 R/F Mk2 Instruction Manual page 56

Chapter 3. OPERATION
FULL SET-UP
Key/selection
SETUP + KEY PRESS
[UNITS]
[NEXT]
[PREV]
[SAVE]
[LIMITS]
[NEXT]
[PREV]
[SEL]
[OSC]
[Ps]
[START]
[STOP]
[FREEZE]
[AMPL/FREQ]
[AMPL]
[FREQ]
[Pt]
[MORE]
[CONTROL]
[Ps Pt DUAL]
[DISPLAYS/OPTIONS]
[DISPLAY TYPE]
[NEXT]
[PREV]
[SAVE]
[I/O SETUP]
[ENET SUPER]
[ENET COMMS]
[OPTIONS]
[CLOSE O/P VALVES]
[OPEN O/P VALVES]
[SYSTEM SELF TEST]
38 | ADTS 405 Mk2 Instruction Manual-English
Data Entry
Data Entry
[-]
[FIXED IP]
[ADDR]
[MASK]
[BCST]
[SHOW ACTIVE]
[-]
[-]
[SHOW ACTIVE]
Function and comments
Select units
Step through available units
Step back though available units
Select displayed units
Select set of limits
(aircraft 1\aircraft 2 ...)
As NEXT, in reverse order
Select displayed limit set
Oscillate about aim
For Ps channel
As for Ps channel
Selects Ps only, Pt only or Dual channel control
Select single, dual or triple display
(SINGLE\DUAL\TRIPLE\ENCODER)
As NEXT, reverse order
Save displayed Display Type
Configure Ethernet
Supervisor node Ethernet parameters
Menu option not available. DHCP select in CONFIG only
Setup fixed IP Address
IP Address
Subnet Mask
Broadcast
Confirm active IP settings
Communications node Ethernet parameters
Menu option not available. DHCP select in CONFIG only
Menu option not available. Fixed IP select in CONFIG
only
Confirm active IP settings
See option manual
Close output valves
Open output valves
Start self test
© 2015 General Electric Company – All rights reserved.