GE Druck ADTS 405 R/F Mk2 Instruction Manual page 113

6.2.59.20 CONFIG, [MORE], [SETUP MODE]
This function enables, disables or limits access to the secondary functions. There are three set-up
modes:
FULL
This mode provides complete access to all secondary functions when the SETUP key is pressed. All
pressure and aeronautical units can be selected.
MINIMUM
This mode provides limited access to the secondary functions when the SETUP key is pressed. This
prevents access to error recovery, rate timers etc. Units can only be changed between two pre-
selected types. See SETUP key section 6.2.25 for full details.
OFF
This mode prevents access to all secondary functions.
6.2.59.21 CONFIG, SPEED, [AUTO ZERO]
CONFIG equivalent of SETUP function.
6.2.59.22 CONFIG, SPEED, [CAS/TAS]
CONFIG equivalent of SETUP function.
6.2.59.23 CONFIG, SPEED, [Pt TEMPERATURE]
CONFIG equivalent of SETUP function.
6.2.59.24 CONFIG, RATE TIMER
CONFIG equivalent of SETUP function.
6.2.59.25 CONFIG, RATE
CONFIG equivalent of SETUP function.
6.2.59.26 CONFIG, LEAK MEASURE, [AUTO LEAK ON/OFF]
CONFIG equivalent of SETUP function, see LEAK MEASURE/CONTROL for details.
6.2.59.27 CONFIG, LEAK MEASURE, [AUTO LEAK LOCK]
Prevents changes to AUTO LEAK setting in SETUP.
6.2.59.28 CONFIG, LEAK MEASURE, [AUTO LIMIT ON/OFF]
CONFIG equivalent of SETUP function, see LEAK MEASURE/CONTROL for details.
6.2.59.29 CONFIG, LEAK MEASURE, [AUTO LIMIT LOCK]
Prevents changes to AUTO LIMIT setting in SETUP.
6.2.59.30 CONFIG, GROUND
CONFIG equivalent of SETUP function.
6.2.59.31 CONFIG, PORT
Refer to the Line Switching Unit User Manual.
© 2015 General Electric Company – All rights reserved.
Introduction
ADTS 405 Mk2 Instruction Manual-English | 95