Using - BDS AutoMAB 350 Operating Instructions Manual

Using

Using
Select the speed range
(AutoMAB 450 only)
ATTENTION
► Switch the gear stages only with the
machine at standstill.
NOTE
► Select the speed range according to
the material and drilling diameter.
Select the gear stage
The machine has a gearbox with two me-
chanical gear stages. The rotation speeds
of the gear stages are specified in the
technical data.
To select the desired gear stage,
‹
set selector lever on the gearbox
(2) to stage 1 or 2 with the machine
switched off.
14
Activating/deactivating the mag-
netic clamp
Activating the magnetic clamp
ATTENTION
► To prevent the magnet from overheat-
ing, switch on the magnetic clamp
only when the machine is standing on
a magnetic substrate.
Turn on the switch (21). The indicator
‹
lamp in the switch (21) lights up.
Check the magnet holding force with
‹
the magnet indicator ("MAGNET
POWER" (22) indicator light).
"MAGNET POWER"
indicator light
GREEN
RED
ATTENTION
► The maximum magnetic holding force
is only available after switching on the
motor.
Deactivating the magnetic clamp
Hold the handle tightly (3) to stop the
‹
machine from slipping.
Turn the switch (21) off. The indicator
‹
lamp in the switch (21) extinguishes.
GB
Magnetic holding
force condition
Sufficient
magnetic holding
force
Insufficient magnet-
ic holding force
AutoMAB 350, 450