Inserting The Tool - BDS AutoMAB 350 Operating Instructions Manual

Preparing
The best clamping effect is obtained on
low-carbon steel substrate with a thickness
of at least 20 mm.
Steel with low thickness
When drilling into low thickness steel, an
additional steel plate (minimum dimensions
100 x 200 x 20 mm) must be placed under
the workpiece. Secure the steel plate to
prevent it from falling.
NF metals or workpieces with an uneven
surface
A special holding device must be used
when drilling into NF metals or into work-
pieces with an uneven surface.
NOTE
► BDS offers a range of accessories
with special holding and clamping
devices for tubes and non-magnetic
materials.
12

Inserting the tool

WARNING
Risk of injury!
► Do not use damaged, contaminated
or worn tools.
► Change tools only when the machine
is switched off and at a standstill. Pull
the plug out of the mains socket.
► After inserting, check that the tool is
engaged securely.
► Only use tools, adapter and accesso-
ries that match the machine.
GB
AutoMAB 350, 450