Zeiss MCS 600 User Manual page 59

MCS 600
MCS 600 | User Manual
3.14.5 Changing the lamp
The cassette must be opened in order to change the lamp.
Warning
Halogen lamp is sensitive!
The slightest traces of dirt and grease on the glass body of the lamp
can impair the intensity and service life of the lamp. Use dust-free,
grease-free rubber gloves when changing the lamp.
Caution
Halogen lamp is hot!
Allow defective lamps to cool!
How to Implement ...
1. Turn the device off and disconnect the power plug.
2. Loosen the four fastening screws and pull the lamp cassette out of the
housing.
3. Loosen the 4 screws on the upper grating and remove the grating.
4. Loosen the knurled screw and carefully remove the lamp from the holder.
2 3
5. Disconnect the lamp connector.
Warning
Do not touch the lens of the new halogen bulb!
6. Install the new lamp
7. Then, reconnect the cable (reverse polarity protection).
8. Reattach the upper grating and tighten the screws.
9. Insert the lamp cassette again and tighten the screws.
10. Reconnect the device to the power supply and turn it on.
4
and slightly tighten the knurled screw again.
5
1
59