Table of Contents
Advertisement
Prune stations
3
If you do not wish to prune stations, select "No" and then
press and release the Tuning control knob to confirm the
setting.
NOTE
If you have moved your radio to a different part of the country you should also carry out a
search for new stations (please see the section 'Finding new stations').
Operating your radio – FM
1.
Straighten the antenna properly above the radio. Press the Power On / Off button to switch on
your radio.
2.
Press the Source button to select FM waveband.
3.
To scan up in frequency, first rotate the Tuning control knob in a clockwise direction and then
press the Auto tune button. Your radio will scan in an upwards direction (low frequency to high
frequency) and stop automatically when it finds a station of sufficient strength. To scan down in
frequency, first rotate the Tuning control knob in a anti-clockwise direction and then press the
Auto tune button. Your radio will scan in a downwards direction and stop automatically when it
finds a station of sufficient strength. After a few seconds the display will update. The display will
show the frequency of the signal found. If the signal is strong enough and there is RDS data
present then the radio will display the station name.
4.
When the waveband end is reached, your radio will recommence tuning from the opposite
waveband end.
5.
Adjust the Volume control to the required setting.
6.
To switch off your radio, press the Power On / Off button.
Manual tuning – FM
1.
Press the Power On / Off button to switch on your radio.
2.
Press the Source button to select FM waveband.
3.
Rotate the Tuning control knob to tune to a station. The frequency will change in steps of 50 kHz.
When the waveband end is reached, the radio will recommence tuning from the opposite waveband end.
4.
Adjust the Volume control to the required setting. To switch off your radio, press the Power On /
Off button.
Prune?
Yes <No>
019
Advertisement
Table of Contents
