IMPORTANT SAFETY INSTRUCTIONS 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
Page 3
10. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. 11. Only use attachments/accessories specified by the manufacturer. 12. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus.
Page 4
The apparatus is not for permanent outdoor use. The U-1 has been fully tested to be certain it meets Sangean quality control standards. Please read this manual carefully before using it to make sure you realize all the outstanding features built into this terrific radio set.
Main features (1) Ultra rugged AM/FM 2 bands radio. (2) Water resistant up to JIS 4 standard. (3) Soft bended spring antenna. (4) Rotary tuning and volume controls. (5) Tuning LED indicator. (6) LED illuminator. (7) Dial Scale with back light. (8) Dynamic Bass Compensation for rich bass.
Page 7
Controls Power and AM/FM/AUX IN band selector Tuning LED indicator Tuning Control Volume Control Battery Compartment AUX/FM band indicator LED illuminator switch DC IN (9-14V) socket for vehicle and boat power LED light Microphone socket AUX IN socket Headphones socket Open to AC cord compartment Loudspeaker AM band /Microphone indicator...
Power the radio 1. Battery operation Installing the batteries, first turn battery cover fixture anti-clockwise to loosen and put down the battery cover. Insert 6 x D size ( UM-1 ) battery into the compartment. Ensure the battery is inserted in accordance with the diagram shown.
Operating your radio FM 1. Turn on the radio by switching the Power knob to FM position. The FM band indicator will be lit on. 2. Rotate the Tuning Control to select the desired station. On FM, the tuning scale is marked in MHz ( Megahertz ). The Tuning LED will be lit on, if the radio station has been correctly tuned.
Headphones socket You can use a stereo or mono headphones set with a 3.5 mm plug for listening radio program via headphones. When you insert the headphones plug, the speaker is disconnected. This is a mono type radio, sound from the headphones set will be all in mono even if you apply a stereo headphones set.
Specifications Frequency Coverage: FM 87.50 - 108 MHz AM 520 - 1710 kHz AC Power: AC 120 V/60Hz/25W (USA) AC 230 V/50 Hz/25W (Europe) Batteries: 6 x UM-1 (D size) DC IN: 12V/1A center pin positive (operational voltage 9-14V), 5.5mm in diameter. Output Power: 4 W 10% T.H.D.
Page 12
MIC IN socket: 6.5 mm diameter, suits for Vocal Dynamic Microphone. Speaker unit: 6.5 inches 8 ohm 15 W , full range Internal Antenna system: AM built-in ferrite aerial FM built in removable bended spring antenna LED illuminator: 3 x white LED, current consumption 50 mA Battery life: Approx.
Need help?
Do you have a question about the U1 and is the answer not in the manual?
Questions and answers