Table of Contents
Advertisement
Charging with USB socket
Your radio has a USB socket which is intended for charging an iPhone, smart phone or similar
devices. Charge time may vary and in some cases may take longer to charge than when using the
manufacturers charging unit supplied with the smart phone. The radio can charge the iPhone, smart
phone or similar devices when using AC power cord and the radio is in power on or standby mode.
IMPORTANT
● The USB jack can only provide power for the USB memory stick only with 1A 5V maximum and
most of iPhone models. However, it does not support external Hard disk drive and all mobile
phones and electronic device.
● The charger may not supply power to some USB devices.
● Do not connect power source to USB port. Otherwise there is risk of fire. The USB port is only
intended for charging lower voltage device.
● Do not insert a nail, wire, etc. into USB power supply port. Otherwise a circuit short may cause
smoke and fire.
● Do not connect this USB socket with your PC USB port, as it is highly possible that it may
cause breakdown of the units.
● Never use the USB socket in rainy or moist conditions to prevent moist from entering the radio.
Loudness On / Off
When the radio is switched on, press and hold the EQ control button to get compensation on lower and
higher frequency. The effect will be more audible when the radio is in lower volume level. The display
will show "Loudness on" when Loudness function is applied. To turn off the loudness function, press
and hold the EQ control button again. The display will show "Loudness off".
Equaliser function
1.
Press the Power On / Off button to switch on your radio.
2.
Press the EQ control button to enter the EQ setting menu.
3.
Rotate the Tuning control knob to select your required mode. Then press the Tuning control knob
to confirm the selection.
030
Advertisement
Table of Contents
