Rack-Mounting The Polycom Soundstructure Device - Polycom SoundStructure C16 Hardware Installation Manual

Hardware Installation Guide for the Polycom SoundStructure

Rack-Mounting the Polycom SoundStructure Device

The Polycom SoundStructure can be mounted in an equipment rack, or placed on a tabletop or other flat
surface, or mounted under the table with the optional undertable mounting kit.
Each SoundStructure device requires one rack space and does not require
additional empty rack spaces above or below the device when mounting additional
SoundStructure devices. When connecting the SoundStructure device to a
RealPresence Group 700, Polycom recommends including one rack unit of space
Warning
between the units.
When multiple devices are racked together, before final tightening of the rack mount
screws on each device after the first one, ensure there is enough clearance so that
the front-panel door will open freely.
To rack-mount the SoundStructure unit:
1 Remove the four front side screws and two mid-side screws on the enclosure.
2 Align the rack ears, and install the rack ears using the screws that were removed from the
enclosure.
3 Mount the equipment in the rack and secure with the four supplied rack mount screws (screw size is
10-32x1/2").
To place on a tabletop or other flat surface:
» If the equipment will not be mounted in an equipment rack, install the four adhesive rubber feet on the
bottom of the device (as shown below) before placing the equipment on furniture.
Polycom, Inc.
®
SoundStructure C16
®
SoundStructure C16
®
SoundStructure C16
14