Polycom SoundStructure C16 Hardware Installation Manual page 13

Hardware Installation Guide for the Polycom SoundStructure
To install a plug-in card:
1 If plugged in, unplug the AC power cord from the SoundStructure device.
2 Remove the blank plate and screws from the expansion slot (see below).
3 Insert the plug-in card into the slotted rails and push until it is tight into the slot.
4 Tighten the thumbscrews on the rear-panel of the plug-in card.
5 If no further installation steps are required, plug in the AC power cable; otherwise, continue with the
remainder of the installation steps prior to applying power.
Polycom, Inc.
LAN C-LINK2
LAN C-LINK2
PHONE
LAN C-LINK2
IN
PIN 2: TXD
PIN 3: RXD
PIN 5: GROUND
PIN 7: CTS
PIN 8: RTS
RS-232
OBAM IR
IN OUT 12V
PIN 2: TXD
PIN 3: RXD
PIN 5: GROUND
PIN 7: CTS
PIN 8: RTS
RS-232
OBAM IR
IN OUT 12V
LINE
PIN 2: TXD
PIN 3: RXD
PIN 5: GROUND
PIN 7: CTS
PIN 8: RTS
RS-232
OBAM IR
OUT 12V
13