Hardware Installation Guide for the Polycom SoundStructure
● Total cancellation: >65 dB
● Convergence rate: 40 dB/second
● Noise cancellation: 0-20 dB, software selectable
● Control inputs: contact closure
● Status outputs: open collector 60 V and 500 mA maximum total per outputs
● All signal ground pins connected to chassis ground through low impedance planes
Telco
● Input gain: -100 to +20 dB in 1 dB steps, software adjustable
● Nominal transmit level: 0 dBu in SoundStructure device yields -15 to -17 dBm to phone (country code
dependent)
● Off hook loop current: 10 mA (minimum) to 120 mA (maximum)
● Output gain: -100 to +20 dB in 1 dB steps, software adjustable
● Frequency response: 250-3300 Hz
● Dynamic range: >70 dB FS, 250-3300 Hz, "A" weighted
Pin Out Summary
Drawings and part numbers are provided for reference only
Other than cables provided by Polycom, Polycom claims no responsibility or liability
for the quality, performance, or reliability of cables based on these reference
Warning
drawings. Contact a Polycom reseller to order cables that meet the appropriate
manufacturing tolerances, quality, and performance parameters for particular
applications.
Conference Link2
To build a custom Conference Link2 cable, use shielded CAT5e, or better, and terminate both end
connectors, P1 and P2, with standard 8P8C plugs (for example, RJ45) using the wiring connections shown
in the following figure. The maximum length for this cable is 100 feet (30 m). Note that this cable provides
a cross-over connection between pins 1 and 2 and pins 5 and 6.
Polycom, Inc.
30