Control - 2N IP Force Installation Manual

3.2 Control

This subsection describes how to control
user.
Speed Dial Buttons
Press the speed dial buttons on the basic unit to make quick dialling for the first 1, 2 or
4 positions (depending on the model type) in the telephone directory. Call setup is
signalled by a long intermittent tone or otherwise as configured in the PBX connected.
Repeated pressing of one and the same speed dial button during call setup may
initiate call termination, or call termination plus dialling the next telephone number of
the called subscriber, or may be assigned no function. This behaviour can be set in
unit configuration.
If your model is equipped with a numerical keypad, you can also push the
anytime to terminate a call if enabled so in the
Calling to Telephone Directory Positions
®
The 2N IP Force
positions. Speed dial can only be used for positions 1 to 4. The remaining positions can
be retrieved via the numerical keypad if the
in configuration.
Procedure:
Enter the position number using your numerical keypad (05, 15, 200, 1759 e.g. –
two digits at least and four digits at most) and press
You can also push the
Hang up with #
Calling to Telephone Number
You can dial a telephone number using your numerical keypad from
the Enable telephone function
Procedure:
Press the button.
1.
You will hear the continuous tone from the loudspeaker.
2.
3.
2N TELEKOMUNIKACE a.s., www.2n.cz
telephone directory can contain up to 1999 pre-programmed
button anytime to terminate a call if enabled so in the
parameter in the unit configuration.
parameter is on.
®
2N IP Force when viewed by an external
Hang up with #
Speed dial using digits
for confirmation.
button
parameter.
function is enabled
®
2N IP Force
101/117
if