SMC Networks ProtoCessor FPC-ED2 Startup Manual page 3

1. Record the information about the unit. (Section 3.1)
2. Set the COM settings for the device connected to ProtoCessor. (Section 3.3)
3. Connect ProtoCessor FPC-ED2's 3 pin RS-485 port to the Field Protocol cabling. (Section 4.2)
4. Use a browser to access the ProtoCessor's embedded tool, which is referred to in this manual as
the Web Configurator, to select the device that will be attached to ProtoCessor. Once the device
is selected, the ProtoCessor Automatically builds and loads the Configuration. (Section 5)
5. BACnet/IP, Modbus TCP/IP or EtherNet/IP: Use a browser to access the ProtoCessor Web
Configurator to change the IP Address. No changes to the configuration are necessary. (Section
5.5)
Leonard Valve ProtoCessor Start-up Guide
Quick Start Guide
Page 3 of 32