Check Wiring And Settings - SMC Networks ProtoCessor FPC-ED2 Startup Manual

Check Wiring and Settings

•
No COMS on PSP side. If the Tx/Rx LEDs are not flashing rapidly then there is a COM issue. To
fix, check the following:
o
Visual observations of LEDs on ProtoCessor
o
Check baud rate, parity, data bits, stop bits
o
Check device address
o
Verify device is connected to the same subnet as the ProtoCessor
o
Verify the Modbus device was discovered in Web Configurator (Section 5.2)
•
Field COM problems:
o
If Ethernet protocols are used, observe Ethernet LEDs on the ProtoCessor
A.4)
o
Check dipswitch settings (using correct baud rate and device instance)
o
Verify IP Address setting
o
Verify wiring
NOTE: If the problem persists, a Diagnostic Capture needs to be taken and sent to support.
(Appendix A.5)
Leonard Valve ProtoCessor Start-up Guide
(Appendix
Page 23 of 32
A.4)
(Appendix