Usb Gps Module - Hardkernnel ODROID-C2 User Manual

bcdUSB
bDeviceClass
bDeviceSubClass
bDeviceProtocol
bMaxPacketSize0
idVendor
idProduct
bcdDevice
iManufacturer
iProduct
iSerial
bNumConfigurations
...
SSD used with SATA bridge board
the storage device attached. The following command shows how it
would appear to the system:
$ df -h
Filesystem
...
/dev/sda1
hdd-01
age device.

USB GPS Module

face that supports the standard National Marine Electronics Associa-
tion (NMEA) GPS protocol, as shown next page.
into the official Hardkernel Lubuntu image. One should be able to at-
tach the device to an available USB port on the C2 and start using it
right away:
78
ODROID C2 USER MANUAL
2.10
64
0x05e3 Genesys Logic, Inc.
0x0735
10.03
1
You can use the procedure listed in the previous section to mount
Size Used Avail Use% Mounted on
46G
Once mounted this way, you can proceed to use the SATA stor-
Hardkernel produces a 5V 0.1A GPS receiver with an USB inter-
The device uses a Ublox 6010 chipset, with support already built
0 (Defined at Interface level)
0
0
1 USB Storage
2 USB3.0 SATA Bridge
3 0000000000000033
52M 44G 1% /media/odroid/odroid-c2-
Chapter 4