Hardkernnel ODROID-C2 User Manual page 61

can be reloaded and used anytime, as long as the C2's ip-address and
hostname remain the same. Click on the Open button to start a session.
and password, which are typically "odroid" and "odroid". You will see
a screen presented as shown in the image below.
PuTTY SSH console
terminal window. While you cannot view the boot log in real-time, you
can run a large number of Linux commands (including dmesg) from
this ssh session.
a Windows 7+ system. Next, we present information on the use of a
Ubuntu desktop Linux host system. Most of the steps apply to a host
system running any Linux version, including a server OS. The steps
do not address the use of Linux hosted in a virtual environment, such
as VirtualBox.
Linux Host Setup
nal session. Attach the USB cable from the USB / UART setup to the
host system. The following commands can be used to verify proper
installation:
$ lsusb
...
Bus 004 Device 003: ID 10c4:ea60 Cygnal Integrated Products, Inc.
CP210x UART Bridge / myAVR mySmartUSB light
...
Using the output above, you get obtain additional details of the USB /
UART module, using the command:
$ sudo lsusb -D /dev/bus/usb/004/003
Device: ID 10c4:ea60 Cygnal Integrated Products, Inc.
Bridge / myAVR mySmartUSB light
56
ODROID C2 USER MANUAL
Reboot the C2, and you will then be prompted for the user's ID
You can access the C2 system as if you had locally opened a
So far, we've addressed the case where the host PC system is
Access the Linux desktop of the host system and launch a termi-
Chapter 4
CP210x UART