Hardkernnel ODROID-C2 User Manual page 81

bcdDevice
iManufacturer
iProduct
iSerial
bNumConfigurations
...
ASM1051E single-chip based SuperSpeed USB (USB 3.0) to Serial
ATA3 bridge.
ically detected by the docking system. You can follow these steps to
use the storage device on an ODROID-C2:
$ sudo apt-get install gparted
Administration menu. Select the device, which will typically be named
/dev/sda if no other storage devices exist on the system. Highlight the
unallocated partition and select the Device > Create Partition Table
menu item. You will be presented with a warning as shown below.
Partition creation warning
and select the Partition > New menu item. You will be presented with
a screen to enter the new partition's information, as shown below:
New partition information
Enter a label name odroid-c2-hdd-01, and click the Add button. Select
the new partition and Click on the check icon, to apply/save all changes.
the creation of the new partition:
76
ODROID C2 USER MANUAL
1.00
1
As shown in the output, the docking system uses the ASMedia's
A brand new storage device, if unformatted, will not be automat-
First, install GParted using the command:
Then start the GParted application from the desktop's System >
Click the Apply button, then highlight the unallocated partition
Reboot the system and run the following command to validate
Chapter 4
2 Asmedia
3 ASM1051
1 0123456789ABCDEF0124