Hardkernnel ODROID-C2 User Manual page 67

• 40pin Male-to-Male Dupont jumper Wire 170mm
• Green/Yellow/Red 3mm LEDs – 7 each
• 2 x Photocell (CdS Light sensor), 6 x Tact Switches
• 330 Ω / 10 KΩ 1/6W resistors – 50 each
Tinkering Kit
GPIO layout for the 40-pin header on the ODROID-C2
header onto a solderless breadboard. The pins include, power, GPIO,
I2C, and ADC pins. This simplifies prototyping of data acquisition and
control projects.
bit.ly/2bfeRFF
the designation of the 40 pins. Use the data sheet and this information
with caution when applying voltages to the pins, to ensure compliance
62
ODROID C2 USER MANUAL
The T-breakout board breaks-out all the pins from the 40-pin
It is advisable to refer to the Amlogic S905 data sheet at
to fully understand the GPIO designations.
The above image illustrates simplified information on layout and
Chapter 4
http://