Hardkernnel ODROID-C2 User Manual page 62

Device Descriptor:
bLength
bDescriptorType
bcdUSB
bDeviceClass
bDeviceSubClass
bDeviceProtocol
bMaxPacketSize0
idVendor
idProduct
light
bcdDevice
iManufacturer
iProduct
iSerial
bNumConfigurations
...
The TTY port on which the module is detected, can be obtained:
$ sudo ls -lsa /dev/tty* | grep USB
0 crw-rw---- 1 root dialout 188,
The lockfile location can be checked using the command:
$ sudo ls -lsa /var/lock*
0 lrwxrwxrwx 1 root root 9 Aug 12
This information is used to setup the communications between the
host system and USB / UART cable attached to the ODROID-C2. The
application used to enable communication will be Minicom:
$ minicom -version
minicom version 2.6.1 (compiled May
Copyright (C) Miquel van Smoorenburg.
...
Launch Minicom using the following command:
$ sudo minicom -o -s
Here are the four screens you would go through to configure and use
minicom in the next page:
The four steps include:
screen 2.
that used on your system. In this case it is:
57
ODROID C2 USER MANUAL
0x10c4 Cygnal Integrated Products, Inc.
0xea60 CP210x UART Bridge / myAVR mySmartUSB
Select the Serial port setup option and you will be presented with
In screen 2, type A to select option A. Edit the serial device to
18
1
2.00
0 (Defined at Interface level)
0
0
64
1.00
1 Silicon Labs
2 CP2104 USB to UART Bridge Controller
3 00513B0C
1
0 Aug 12 16:48 /dev/ttyUSB0
2016 /var/lock -> /run/lock
1 2012)
Chapter 4
. Ensure the
/dev/ttyUSB0