Hardkernnel ODROID-C2 User Manual page 23

Chapter 1
• 1024x768 (XGA)
• 1024x600 (WSVGA: VU7+)
• 800x600 (SVGA)
• 800x480 (WVGA: VU7)
• 640x480 (VGA)
Can I use an HDMI to DVI converter?
An HDMI-DVI converter may work with many DVI monitors, but a few
of them will not work due to compatibility issues. We recommend our
7-inch HDMI LCD kit (ODROID-VU7 or ODROID-VU7+) with a 5-point
capacitive touch screen if you want to develop a modern user inter-
face.
Is there a touch screen on the 9-inch HDMI LCD Kit?
No.
Is sound over HDMI supported?
Yes.
Is SPDIF and optical pass-through supported?
It is possible with our USB to SPDIF interface, available at the Hard-
kernel store, but it only works with Kodi (XBMC) on Ubuntu. The An-
droid platform does not yet support the 5.1 channel pass-through.
Is there any analog audio output or input?
Not on the board itself, but you can use our USB Audio Adapter for
analog audio or the HiFi Shield Plus.
Is there an I2S port to connect a HiFi DAC?
No, but an ODROID Hi-Fi Shield may be used with the ODROID-C2.
What is an eMMC 5.0 module?
The eMMC 5.0 module is a NAND flash-based storage IC which is
mounted on a custom PCB for easier upgrade/replacement, and is
much faster than SD card. The read/write speed of a typical eMMC
5.0 is approximately 125MB/sec, while a microSD UHS-1 card is ap-
proximately 15MB/sec and 30MB/sec respectively.
Do you have a SATA port?
No, but you can use Hardkernel's USB3-to-SATA bridge device.
Which power adapter should I use?
The ODROID-C2 consumes less than 0.5A in most cases, but it can
18
ODROID C2 USER MANUAL