Usb3 To Sata Bridge Board - Hardkernnel ODROID-C2 User Manual

$ df -h
Filesystem
udev
tmpfs
/dev/mmcblk0p2
tmpfs
tmpfs
tmpfs
/dev/mmcblk0p1
cgmfs
tmpfs
tmpfs
/dev/sda1
hdd-01
the Places > Computer menu from the desktop, which should show
that the HDD has been installed and mounted, and is ready for use.

USB3 to SATA Bridge Board

GL3321G) that allows interfacing of a single 2.5" SATA HDD/SDD.
While providing power to the storage, it also provides access to the
data stored on the attached SATA storage device.
SATA bridge board
sert the compatible SATA storage device into the bridge board. Attach
the included USB cable to both the board and the ODROID-C2 and
power up the SBC.
commands:
$ lsusb
Bus 001 Device 004: ID 05e3:0735 Genesys Logic, Inc.
$ sudo lsusb -D /dev/bus/usb/001/004
Device: ID 05e3:0735 Genesys Logic, Inc.
Device Descriptor:
bLength
bDescriptorType
77
ODROID C2 USER MANUAL
Size Used Avail Use% Mounted on
733M 0
172M 7.3M 165M
29G
859M 184K 859M
5.0M 4.0K 5.0M
859M 0
128M
100K 0
172M 4.0K 172M
172M 24K
46G
You can also verify using the Console application by selecting
This board contains a USB3.0 to SATA3 controller (Genesis
To use the controller, first power down the ODROID-C2, then in-
Details about the accessory can be found using the following
18
733M 0% /dev
5% /run
6.2G 22G 23% /
1% /dev/shm
1% /run/lock
859M 0% /sys/fs/cgroup
22M 107M 17% /media/boot
100K 0% /run/cgmanager/fs
1% /run/user/118
172M 1% /run/user/1000
52M 44G 1% /media/odroid/odroid-c2-
1
Chapter 4