The Wiring Board Ports Definition - Digital Dream DM500 User Manual

2.2 The Wiring Board Ports definition

Pin Mark
24V Power supply 24VDC positive side for System power
Power supply 24VDC negative side for system power
GND
PE SHELL GROUND
COM+ Power supply 24VDC positive side for Inputs and Output Ports.
Power supply 24VDC negative side for Inputs and Output Ports.
COM-
XP+ X Axis Pulse signal output +
XP- X Axis Pulse signal output -
XD+ X Axis Direction signal output+
XD- X Axis Direction signal output -
Y Axis Pulse signal output +
YP+
YP- Y Axis Pulse signal output -
YD+ Y Axis Direction signal output+
YD- Y Axis Direction signal output -
ZP+ Z Axis Pulse signal output +
ZP- Z Axis Pulse signal output -
ZD+ Z Axis Direction signal output+
ZD- Z Axis Direction signal output -
A Axis Pulse signal output +
AP+
AP- A Axis Pulse signal output -
AD+ A Axis Direction signal output+
AD- A Axis Direction signal output -
X01 X Axis Limit/Home Signal Input Port
X02 Y Axis Limit/Home Signal Input Port
X03 Z Axis Limit/Home Signal Input Port
X04 A Axis Limit/Home Signal Input Port
Probe Signal Input Port
X05
X06 Extended Input Port 1,can be configured as E-STOP
X07 Extended Input Port 2,can be configured as Start or Probe
X08 Extended Input Port 3,can be configured as Pause
Y01 Spindle Start/Stop Output Port
Y02 Spindle Speed Setting 1 Output Port
Y03 Spindle Speed Setting 2 Output Port
Y04 Spindle Speed Setting 3 Output Port
Alarm Output
Y05
Y06 Cooling output Port (M8/M9)
Y07 Lubrication output Port (M10/M11)
RXD Receive Port of communication
TXD Send Port of Communication
GND Ground of Communication Port
Definition
Page -7
Notes
The Power Supply is for controller system.DC24V,3A.
The Power Supply is for Input and Output Ports.DC24V,3A.
These Outputs is for Servo Driver/Stepper Driver.
Max. output 500Khz for each axis.
These all Input Ports.
Support mechanical/Opto/Proximity Limited Switch
Limited Switch Power:24V
Mode: NPN
Effective Voltage:0V
These Output ports for the controls of Spindle.
Y02/Y03/Y03 are for settings of spindle 8 different speeds.
Open-collector output,installed,Current:500mA,Voltage:30V
RS232
DM500 User's Manual