Table of Contents
Advertisement
5.5 Running a G code file
5.5.1 Load a G Code File
Pls Insert the U-disk into the interface of the controller.The G-code files are in the U-disk.
Conditions:
• Controller is in READY status;
Operations:
• Insert a U-disk;
• Press the Key of Menu and shift to the "File Page",the screen will pop up the files list of U-disk.
• Use the key of
and
to page left and right,to find the G-code file you want to run.
• Press the key
file is the current running file.
5.5.2 Run a G-code file
By previewing and simulating toolpath Function,you can check if the G code file is correct.
Conditions:
• Controller is in READY status;
Operations:
• Press MENU key and shift to File Page.The screen popup the files list from U-disk.
• Use the key of
page
left and right,to find the G-code file you want to run.
• Press the key
file is the current running file.
• Press the Key of start
5.5.3 The Operation of running a G-code File
5.5.3.1
Breakpoint Operation
When there is Power-cutoff,Reset,E-stop,Limted-switch alarm and U-disk disconnected happened,that
will produce a breakpoints.But,our system can automatically record the breakpoints and continue to process
from the breakpoint.
Conditions:
• Controller is in READY status;
• The screen go to "Main page"
and
to move the cursor up and down,and press the keys
to load the G-code file,the then screen goes to the control page,and the selected
and
to move the cursor up and down,and press the keys and to
to load the G-code file,the then screen goes to the control page,and the selected
and the contoller start to run the file you selected.
Page -28
DM500 User's Manual
Hide quick links:
Advertisement
Table of Contents
