Set A Zero(Origin) Point For Workpiece; Xy Axis And Za Axis Zero Clearing; Single Axis Zero Clearing (Take X Axis As Example); Workpiece Origin Position Save And Load - Digital Dream DM500 User Manual

Operation:
• Continuously Press the Key
• Keep on pressing
current coordinate.

5.3.2 Set a Zero(Origin) Point for workpiece

5.3.2.1

XY axis and ZA Axis Zero Clearing

After the workpeice coordinate seleted and before running a G-code,the users should adjust the position the
workpiece and the cutter(Z axis position) manually.
Firstly move the X and Y axis to the origin position manually,Press the Key to
axis Zero-clearing.Then Move the Z (and A) axis to the origin position manully and press the
to make Z (and A) axis Zero-Clearing.
5.3.2.2

Single Axis Zero Clearing (Take X Axis as example)

When the controller is at READY status.Move X Axis to the origin position manually.Press the Key
and then press
Clear
5.3.2.3

Workpiece origin position save and load

Conditions:
• Controller is in READY status;
• The screen go to "Main page".
Operation (Take Example as X axis):
• Press the key
to save the Origin Position
• Successively press the Key
to load the origin position.
until the cursor is on coordinate G54-G59 is highlighted;
until your coordinate is selected; The current position always refers to the
and ,then write into "0" and press the key
X Axis Clear
Mul Origin
and then and
and then Mul Origin
Page -25
Save origin
,then Press
and Load Origin
make X and Y
key
.
to confirm
,then press
DM500 User's Manual