Step Mode; Running A G Code File; Start Running G Code - Digital Dream DM500 User Manual

Operation:
• Press the key
• Select and press the axis key (X+、X-、Y+、Y-、Z+、Z-、A+、A-),then the controller feed in high
speed continuously.
• keep on pressing the axis direction key,that can make it moving continuously at high speed;
• The speed can be set at "SJR" or parameter adjustment.
Notice:
Normally the high feeding speed is faster then the low feeding speed,pls confirm the axis direction before
opretation,be sure the safety for the operator and machine.
5.2.3.3

Step Mode

Manual Step Mode,each axis can be jogged in defined steps
Conditions:
• Controller is in READY status;
• Operate mode is STEP
Operation:
• Select and press a key(X+、X-、Y+、Y-、Z+、Z-、A+、A-) the machine jog at the certain direction
and axis;
• press one time and jog at a defined step;
• In STEP MODE,the distance of one jog is 0.01mm/0.1mm/1mm/10mm
• Press combination keys
• The STEP jogging speed is same as the ones when in CONT Mode.

5.2.4 Running a G Code File

5.2.4.1

Start running G code

Conditions:
• Controller is in READY status;
• The operation mode shift to "CONT" or "STEP" mode
Operation:
• Press the start key;
• the controller will start to process the G-code file selected;
• The controller status shift from "READY" to "BUSY"
• When the work finished,the controller status back to "READY".
and shift into high speed mode
and or
Page -23
to change the STEP distance;
DM500 User's Manual