Start A G Code From A Specific Line; Start A G Code From The Nearest Position; Feed Rate Override(Fro) - Digital Dream DM500 User Manual

Operation:
• Press the key
Notice:
Only when you can find out the right origin positon after power cutoff,then you can work again from the
breakpoint,or the position is no right.
5.5.3.2

Start a G code from a specific line

Conditions:
• Controller is in READY status;
• The screen go to "Main page"
Operation:
• Press the key
• Enter into the specific line No.s.Then Press the key
G-code from this line.
Notice:
If the line No. is very big,then the system may need more time to find the line.
5.5.3.3

Start a G code from the nearest position

Conditions:
• Controller is in READY status;
• The screen go to "Main page"
Operation:
• Move the cutter near the workpeice.Press the key
will find a nearest point from the position of the cutter and start to process from this nearest point.
Notice:
The Controller only can find the nearest point from X and Y axis of the coordinate.
5.5.3.4

Feed Rate Override(FRO)

FRO controls the the machine real time Feed Speed.Use A+ and Z- to adjust the Feed Speed in 10%
increments.The relationship betwen the real time feed speed and the F value is:
Real time feed speed=F(Feeding Value) x FRO
Conditions:
• Controller is in READY status;
• The screen go to "Main page"
,and the controller will start to work again from the breakpoint line.
,and press and enter into it to press
Start Line
Page -29
to confirm.The controller will run the
,and press ,then controller
Nearest Point
DM500 User's Manual