Chapter 8 Record Settings; Configuring Record Schedule - HIKVISION DS-6700HUHI-K Series User Manual

Chapter 8 Record Settings

Before you start
Make sure the encoder is connected with HDD or network disk, and the HDD or network disk has been initialized
for the first time to use.

8.1 Configuring Record Schedule

Purpose:
Set the record schedule, and then the camera will automatically start/stop recording according to the configured
schedule.
Steps:
1. Go to Configuration > Storage > Schedule Settings > Record Schedule to enter record schedule settings
page.
2. Select the Camera to configure the record schedule.
3. Check the checkbox of Enable to enable scheduled recording.
4. Select a Record Type. The record type can be Continuous, Motion Detection, Alarm, Motion | Alarm, Motion
& Alarm, and Event.
 Continuous
If you select Continuous, the video will be recorded automatically according to the time of the schedule.
 Record Triggered by Motion Detection
If you select Motion Detection, the video will be recorded when the motion is detected.
Besides configuring the record schedule, you have to set the motion detection area and check the
DS-6700HUHI-K Series Encoder User Manual
Figure 8. 1 Record Schedule Settings
65