HIKVISION DS-6700HUHI-K Series Quick Start Manual

HIKVISION DS-6700HUHI-K Series Quick Start Manual

Hide thumbs Also See for DS-6700HUHI-K Series:

Advertisement

Quick Links

DS-6700HUHI-K Series Encoder
Quick Start Guide
UD07061B
5

Advertisement

Table of Contents
loading

Summary of Contents for HIKVISION DS-6700HUHI-K Series

  • Page 1 DS-6700HUHI-K Series Encoder Quick Start Guide UD07061B...
  • Page 2 (hereinafter referred to be “the Manual”) cannot be reproduced, changed, translated, or distributed, partially or wholly, by any means, without the prior written permission of Hikvision. Unless otherwise stipulated, Hikvision does not make any warranties, guarantees or representations, express or implied, regarding to the Manual.
  • Page 3 DS-6700HUHI-K Series Encoder Quick Start Guide Regulatory Information FCC Information Please take attention that changes or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. FCC compliance: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
  • Page 4 DS-6700HUHI-K Series Encoder Quick Start Guide Applicable Models This manual is applicable to the models listed in the following table. Series Model DS-6704HUHI-K DS-6700HUHI-K DS-6708HUHI-K DS-6716HUHI-K Symbol Conventions The symbols that may be found in this document are defined as follows.
  • Page 5 DS-6700HUHI-K Series Encoder Quick Start Guide Preventive and Cautionary Tips Before connecting and operating your device, please be advised of the following tips: • Ensure unit is installed in a well-ventilated, dust-free environment. • Unit is designed for indoor use only.
  • Page 6: Table Of Contents

    DS-6700HUHI-K Series Encoder Quick Start Guide Table of Content Chapter 1 Panel Description ........................7 1.1 Front Panel .............................. 7 1.2 Rear Panel ............................... 7 Chapter 2 Installation ..........................9 2.1 Pre-Installation ............................9 2.2 Installation .............................. 9 2.3 Hard Disk Installation ..........................9 Chapter 3 Activation ..........................
  • Page 7: Chapter 1 Panel Description

    DS-6700HUHI-K Series Encoder Quick Start Guide Chapter 1 Panel Description Front Panel Figure 1. 1 DS-6704HUHI-K Front Panel Figure 1. 2 DS-6708/6716HUHI-K Front Panel Table 1. 1 Indicator Description Indicator Description POWER Lights in green when the device is powered on.
  • Page 8 DS-6700HUHI-K Series Encoder Quick Start Guide The rear panel of DS-6704/6716HUHI-K provides 4/16 video input interfaces. Table 1. 2 Interface Description Description VIDEO IN AUDIO IN, RCA Connector AUDIO OUT, RCA Connector RS-232 Serial Interface LAN Network Interface RS-485 Serial Interface...
  • Page 9: Chapter 2 Installation

    DS-6700HUHI-K Series Encoder Quick Start Guide Chapter 2 Installation Pre-Installation The DS-6700HUHI-K Series Encoder is advanced surveillance equipment that should be installed with care. Please take into consideration the following precautionary steps before installation of the Encoder. 1. Keep all liquids away from the Encoder.
  • Page 10 DS-6700HUHI-K Series Encoder Quick Start Guide Place the HDD into the slot of the chassis and then secure it in position by fastening the screws at the bottom of the chassis. Take out the HDD data line from the accessories box. Plug one end of the data line to the circuit board and the other end to the data line port of HDD.
  • Page 11: Chapter 3 Activation

    DS-6700HUHI-K Series Encoder Quick Start Guide Chapter 3 Activation Activating via Web Browser Steps: Power on the encoder, and connect the encoder to the network. Input the IP address into the address bar of the web browser, and click Enter to enter the activation interface.
  • Page 12 DS-6700HUHI-K Series Encoder Quick Start Guide Figure 3. 2 Main Interface Click the Device Management icon to enter the Device Management interface, as shown in the figure below. Figure 3. 3 Device Management Check the device status from the device list, and select an inactive device.
  • Page 13 DS-6700HUHI-K Series Encoder Quick Start Guide Figure 3. 4 Activation Interface Click OK button to start activation. Click the Modify Netinfo button to pop up the Network Parameter Modification interface, as shown in the figure below. Figure 3. 5 Modify Network Parameter Change the device IP address to the same subnet with your computer by either modifying the IP address manually or checking the checkbox of Enable DHCP.
  • Page 14: Chapter 4 Access Via Web Browser

    DS-6700HUHI-K Series Encoder Quick Start Guide Chapter 4 Access via Web Browser The device can also be accessed by WEB Browser for configuration and operation. The supported WEB browsers include: Internet Explorer 6/7/8/9, Firefox 3.5 and above, Chrome 8 and above, Safari 5.0.2 and above, Windows XP SP1 and above (32-bit).
  • Page 15: Starting Live View

    DS-6700HUHI-K Series Encoder Quick Start Guide Starting Live View In the live view window, select a playing window by clicking the mouse. Double-click a camera from the device list to start the live view. Figure 4. 3 Start Live View You can click on the toolbar to start the live view of all cameras on the device list.
  • Page 16: Operating Ptz Control

    DS-6700HUHI-K Series Encoder Quick Start Guide Operating PTZ Control Before you start: Make sure the encoder is connected with the camera/dome which supports PTZ function. Connect the R+ and terminals of the pan/tilt unit or speed dome to RS-485 T+ and RS-485 T- terminals of the device respectively.
  • Page 17: Recording

    DS-6700HUHI-K Series Encoder Quick Start Guide Adjust speed of pan/tilt movements Start Manual Tracking Start 3D Zoom Recording Before you start Make sure the Encoder is connected with HDD or network disk, and the HDD or network disk has been initialized for the first time to use.
  • Page 18: Playback

    DS-6700HUHI-K Series Encoder Quick Start Guide Playback Purpose: The recorded video files can be remotely played back through the WEB browser. Steps: Click Playback on the menu bar to enter playback interface: Figure 4. 6 Playback Click the camera from the device list for playback.
  • Page 19: Log

    DS-6700HUHI-K Series Encoder Quick Start Guide Icon Operation Icon Operation Select window-division mode Reverse playback Play/Pause Stop playing Slow forward Fast forward Play by single frame Stop all channels from playing Capture pictures in playback mode Download video files Start/Stop clipping video files...
  • Page 20 DS-6700HUHI-K Series Encoder Quick Start Guide Up to 2000 log files can be displayed each time. Figure 4. 12 Search Log You can click Export to save the searched log files to local directory. 030502001070904...
  • Page 21 DS-6700HUHI-K Series Encoder Quick Start Guide...

This manual is also suitable for:

Ds-6708huhi-kDs-6704huhi-kDs-6716huhi-k

Table of Contents