Configuring Upnp Tm Settings - HIKVISION DS-6700HUHI-K Series User Manual

Attached Image: Check the checkbox of Attached Image if you want to send email with attached alarm
images.
Interval: The interval refers to the time between two actions of sending attached pictures.
Authentication (optional): If your mail server requires authentication, check this checkbox to use
authentication to log in to this server and enter the login User Name and Password.
The Receiver table: Select the receiver to which the email is sent. Up to 3 receivers can be configured.
Receiver: The name of user to be notified.
Receiver's Address: The Email address of user to be notified.
4. Click Save to save the Email settings.
Please refer to the following sections for more information:
Configure alarm linking methods with Send Email on Chapter 7.1.1 Configuring Motion Detection, Chapter 7.1.2
Configuring Alarm Input, Chapter 7.1.4 Configuring Video Loss Alarm, Chapter 7.1.5 Configuring Video
Tempering Alarm and Chapter 7.1.6 Handling Exception.
5.3.6 Configuring UPnP
Purpose:
UPnP™ can permit the device seamlessly discover the presence of other network devices on the network and
establish functional network services for data sharing, communications, etc. If you want to use the UPnP™
function to enable the fast connection of the device to the WAN via a router, you should configure the UPnP™
parameters of the device.
Before you start:
If you want to enable the UPnP™ function of the device, you must enable the UPnP™ function of the router to
which your device is connected. When the network working mode of the device is set as multi-address, the Default
Route of the device should be in the same network segment as that of the LAN IP address of the router.
Steps:
1. Go to Configuration > Network > Basic Settings > NAT to enter the NAT settings page.
2. Check Enable UPnP
3. Select the Port Mapping Mode to Automatic or Manual.
When you select Automatic, the mapping ports can be automatically assigned by the router.
When you select Manual, you can customize the value of the external port.
DS-6700HUHI-K Series Encoder User Manual
TM
Settings
TM
to enable the function.
39