Comtech EF Data KPA-040 Installation And Operation Manual page 113

KPA Ku-Band Indoor Solid-State Power Amplifier
Appendix C
Equipment Type Retrieve Equipment Type:
Application
Identification
Local/Remote Entry Local/Remote Control:
Mode Status
KPA-040 Retrieve Local/Remote
<DEV/RET_'cr'
Confirmation: >DEV/RET_xxxxxxx yyyyy'cr''lf']
Application ID: <DEV/AID_xxxxxxx...xxxxx'cr'
Confirmation: >DEV/AID_'cr'xxxxxxxxxxxxxxxxxxxxxxxx'cr'
xxxxxxxxxxxxxxxxxxxxxxxx'cr''lf']
Retrieve ID: <DEV/AID_'cr'
>DEV/AID_'cr'xxxxxxxxxxxxxxxxxxxxxxxx'cr'
Confirmation:
xxxxxxxxxxxxxxxxxxxxxxxx'cr''lf'
<DEV/LRS_x'cr'
Confirmation: >DEV/LRS_x'cr''lf']
<DEV/LRS_'cr'
Status:
>DEV/LRS_x'cr''lf']
Confirmation:
Where: xxxxxxx = Model No.
yyyyy = Software Version
Example: >DEV/RET_K080-4045-I SW_1.02
Equipment Type is a command that retrieves the model number
and software version of the equipment. The information cannot be
changed by command.
Where: XXXXXXX ...XXXXX = Message, maximum 48
characters
The Application Identification (AID) command allows a free form
message to be created. It is intended to identify the satellite
transponder, beam, destination or other aspects of the application
that may be significant to operations. The message length
corresponds to capability of the LCD and is 48 characters in total.
The second line begins at character 25; therefore, blanks must be
used after line 1 information in order to space to line 2. A carriage
return ends the command. Trailing blanks will be generated to fill
the LCD field. The AID display will alternate with the Equipment
type display by use of the clear function key on the front panel. The
default is "AID MESSAGE."
Where: x= 0 for Local or 1 for Remote
C–19
Revision 1
MN/KPA.IOM