Using The Setup Utility - Lenovo ThinkServer sd350 Installation And Service Manual

• Support GPT partition mode (>2.2 TB volumes and arrays)
• Support Hypervisors install
• Server Introduction (Chinese and English only)
Windows only features
• Allow entries for GUI Run-Once line variables
• Install windows components
• Network configuration
• Auto-generate computer name

Using the Setup utility

Use these instructions to start the Setup utility.
Use the Unified Extensible Firmware Interface (UEFI) Setup Utility program to perform the following tasks:
• View configuration information
• View and change assignments for devices and I/O ports
• Set the date and time
• Set and change passwords
• Set the startup characteristics of the server and the order of startup devices
• Set and change settings for advanced hardware features
• View, set, and change settings for power-management features
• View and clear error logs
• Change interrupt request (IRQ) settings
• Resolve configuration conflicts
Starting the Setup utility
Use this information to start up the Setup utility.
To start the Setup utility, complete the following steps:
Step 1. Turn on the server.
Note: Approximately 5 to 10 seconds after the server is connected to power, the power-control
button becomes active.
When the prompt <F1> Setup is displayed, press F1. If you have set an administrator password,
Step 2.
you must type the administrator password to access the full Setup utility menu. If you do not type
the administrator password, a limited Setup utility menu is available.
Step 3. Select settings to view or change.
Setup utility menu choices
Use the Setup utility main menu to view and configure server configuration data and settings.
The following choices are on the Setup utility main menu for the UEFI. Depending on the version of the
firmware, some menu choices might differ slightly from these descriptions.
• Main
34
Lenovo ThinkServer sd350 Server Type 5493, Lenovo ThinkServer n400 Enclosure Type 5495Installation and Service Guide