Lenovo ThinkServer sd350 Installation And Service Manual page 182

0C6F04E2
296F00E3 Battery_Status
126F05E4 Timestamp
1E6F03E5 Device_OPROM
136F07E6
PCIE_Status
136F08E6
166
Lenovo ThinkServer sd350 Server Type 5493, Lenovo ThinkServer n400 Enclosure Type 5495Installation and Service Guide
Sensor Type: Memory
Event Severity: Critical
Description: Memory
Device Disabled -
Asserted
Sensor Type: Battery
Event Severity: Warning
Description: Battery Low
- Asserted
Sensor Type: System
Event Event Severity: Info
Description: Timestamp
Clock Synch - Asserted
Sensor Type: Boot Error
Event Severity: Warning
Description: Invalid Boot
Sector - Asserted
Sensor Type: Critical
Interrupt Event Severity:
Critical Description:
Bus Correctable Error -
Asserted
Sensor Type: Critical
Interrupt Event Severity:
Critical Description: Bus
Uncorrectable Error -
Asserted
requirements for sparing/paring modes). If
problem follows a moved DIMM to a different
memory channel, replace that DIMM. 5.
(Trained service technician only) Remove
affected Processor and inspect Processor
socket pins for damaged or mis-aligned pins.
If damage is found, or this is an upgrade
Processor, replace the system board. If there
are multiple Processor's, swap Processor's to
move affected Procesor to another Processor
socket and retry. If problem follows the
affected Processor (or there is only one
Processor), replace the affected Processor.
6. (Trained technician only)If problem stays
with the original DIMM connector, re-inspect
DIMM connector for foreign material and
remove, if found. If connector is damaged,
replace system board
1. If the DIMM was disabled because of a
memory fault, follow the procedure for that
event. 2. If problem persists, Power cycle the
Memory fault
node from management console. 3. Reset
occurs and it's
UEFI to default settings. 4. Swap/reseat the
disabled by BIOS.
DIMM from the disabled slot with a matching
DIMM. If the slot remains disabled, (trained
technician only) replace system board
1. If the system was recently installed,
moved, or serviced, make sure the battery is
properly seated. 2. Check Lenovo support
The battery is too
site for an applicable service bulletin or
low.
firmware update that applies to this error.
3. Replace CMOS battery. 4. (Trained
technician only) Replace the system board.
The system time
in BMC was It is just an information. Users don't need to
synchronized with do anything.
BIOS.
Check the Lenovo support website for any
Optoin ROMs are applicable service bulletin or UEFI or adapter
full in memory firmware update that applies to this error.
space. Note: It may be necessary to disable unused
option ROMs from BIOS setup.
If this node and/or any attached cables
were recently installed, moved, serviced or
A single bit error is upgraded, a. Reset adapter and any attached
occurred in PCIe cables. b. Reload Device Driver. c. If
bus. This error device is not recognized, reconfiguring slot to
will be repaired Gen1 or Gen2 may be required. Gen1/Gen2
automatically. settings can be configured via F1 Setup ->
System Settings -> Devices and I/O Ports ->
PCIe Gen1/Gen2/Gen3 Speed Selection
1. Check the Lenovo support website
A multiple bits error
for an applicable device driver, firmware
is occurred in PCIe
update, version of service information for this
bus. This error will
product or other information that applies to
cause system to be
this error. Load new device driver and any
hang up.
required firmware updates. 2. if this node
and/or any attached cables were recently