Enlarging/Reducing The Image Before Transmission - Sharp MX-M350N Facsimile Operation Manual

Facsimile expansion kit
Hide thumbs Also See for MX-M350N:
Table of Contents

Advertisement

SENDING A FAX

ENLARGING/REDUCING THE IMAGE BEFORE TRANSMISSION

Follow these steps to enlarge or reduce the scanned image before transmission.
1
Make sure the machine is in fax mode.
MODE SWITCH
FAX
E-MAIL/FTP
INTERNET FAX
SPEAKER
FAX
MODE SWITCH
2
Load the original.
Using the automatic document feeder: Page 1-7
Using the document glass: Page 1-7
If you are using the document glass to send
multiple pages, load the first page first.
NOTE
You cannot load documents in both the automatic
document feeder and on the document glass and
send them in a single fax transmission.
3
Touch the [ORIGINAL] key.
RESOLUTION
AUTO
A3
ORIGINAL
2-6
When
the
[IMAGE
SEND] key light is on,
the machine is in fax
mode. If the light is not
on, press the [IMAGE
SEND] key.
If the network scanner
option is installed, touch
the [MODE SWITCH]
key and then the [FAX]
key to switch to fax
mode.
When
fax
mode
is
selected, "FAX" appears
in the top half of the
[MODE SWITCH] key.
4
Check the original size.
SCAN SIZE
100%
AUTO
A3
2-SIDED
2-
BOOKLET
TA
NOTE
A long size, stored size, or non-standard size cannot
be specified for the original scanning size.
5
Touch the key under [SEND SIZE].
SEND SIZE
00%
AUTO
2-SIDED
TABLET
6
Touch the key of the desired enlargement
or reduction size.
A5
A4
A5R
A4R
B5
B4
B5R
7
Touch the OK key.
8
Check the enlargement or reduction ratio
and touch the [OK] key.
SPEAKER
RESEND
OK
SEND SIZE
70%
A4
2-SIDED
TABLET
9
Continue
from
PROCEDURE FOR SENDING FAXES"
(pages 2-2 to 2-3).
NOTE
After the transmission is stored, the [CA] key can be
pressed to cancel enlargement/reduction transmission.
If the original size has not
been correctly detected,
touch the key under
[SCAN SIZE] and specify
the original size. (See
"MANUALLY SETTING
THE SCANNING SIZE"
on page 1-8)
If the key under [SEND
SIZE] is greyed out,
specify
a
standard
original size in step 4.
The [AUTO] key is no
longer highlighted. The
[MANUAL] key and the
selected size key are
highlighted.
step
4
of
"BASIC

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mx-m450nMx-m350uMx-m450uAr-fx12

Table of Contents