Administrator Settings - Sharp MX-M350N Facsimile Operation Manual

[SYSTEM SETTINGS] Key
The [SYSTEM SETTINGS] key on the operation panel is called the [CUSTOM SETTINGS] key in the Operation
manual (for facsimile). When configuring system settings, refer to the illustration below. At other places in the
Operation manual that refer to the "Custom Settings", substitute "System Settings".
Location in Operation manual
(for facsimile)
* With respect to the administrator settings, see the following.

2. ADMINISTRATOR SETTINGS

The "Administrator Settings" in the system settings are referred to as "Key Operator Programs" in the Operation
manual (for facsimile). For explanations of the administrator settings for the fax function, see chapter 8, "KEY
OPERATOR PROGRAMS", in the Operation manual (for facsimile).
At places in the Operation manual (for facsimile) that refer to the "Key Operator Programs", substitute "Administrator
Settings".
Due to this change, steps 1 to 3 on pages 8-3 and 8-11 are as follows.
Press the [SYSTEM SETTINGS] key.
1
SYSTEM
B STATUS SETTINGS
Touch the [ADMINISTRATOR SETTINGS]
2
key.
FAX DATA
SENDER CONTROL
RECEIVE/FORWARD
ADMINISTRATOR SETTINGS
When using the MX-M350U/
M450U/M350N/M450N
SYSTEM
S SETTINGS
SYSTEM
B STATUS SETTINGS
Applicable function
USING THE TRANSFER
FUNCTION
Changes in the fax reception
function
STORING, EDITING, AND
DELETING AUTO DIAL
KEYS AND PROGRAMS
STORING A GROUP INDEX
PROGRAMMING,
EDITING, AND DELETING
FCODE MEMORY BOXES
EDITING AND DELETING
A MEMORY BOX
PRINTING PROGRAMMED
INFORMATION
ADMINISTRATOR
SETTINGS*
Enter the administrator password (5-digit
3
number) with the numeric keys.
ADMINISTRATOR PASSWORD
For the steps that follow, see pages 8-3 and 8-11 of the
Operation manual (for facsimile).
Operation manual page
(chapter)
Page 3-18
Page 5-2
Page 6-2
Page 6-9
Page 6-10
Page 6-14
Page 6-14
Chapter 8
The factory default
administrator password
is indicated on page 2 of
Administrator settings
guide.