Programming Frequently Used Operations; Using A Program - Sharp AR-M237 Copier Manual

PROGRAMMING FREQUENTLY
USED OPERATIONS
This function allows you to store the steps of an operation, including the destination and scanning settings, into a
program. When you want to send a document to that destination, you can simply press the appropriate program key
and the steps will be performed automatically. This function is convenient when you frequently send documents
such as a daily report to the same destination. Up to eight programs can be stored.
• A program differs from a timer transmission (p.30) in that it is not cleared from memory after transmission
Note
takes place. A program thus allows you to repeatedly perform the same type of transmission. Note, however,
that programs do not allow you to establish a timer setting for transmission.
• With the exception of polling, reception operations cannot be stored in a program.
Programs can be stored using the custom settings, and a name up to 36 characters long can be assigned.
For information on storing, editing, and deleting programs, see "STORING A PROGRAM" on page 73.
The following settings can be stored in a program:
• Destination fax number • POLLING • SLOW SCAN MODE • DUAL PAGE SCAN • COVER SHEET
• TX MESSAGE • OWN PASSCODE SELECT • CONFIDENTIAL TX • RELAY BROADCAST
• RESOLUTION and EXPOSURE
Auto-dial keys (rapid or group keys) can be used to store the destination fax number, or a full number can be
entered using the numeric keys. When storing a broadcast transmission or serial polling operation in a program, up
to 200 destination fax numbers can be stored.

USING A PROGRAM

1
In fax mode, load the document. (p.10)
SCAN
DATA
LINE
FAX
DATA
CUSTOM SE
JOB STATUS
2
Touch the [SPECIAL MODES] key and
then the [PROGRAM] key.
SUB ADDRESS
SPECIAL MODES ADDRESS REVIEW
DIRECT TX MEMORY TX
POLLING
DUAL PAGE
PROGRAM
SCAN
Do not load a document
if you are performing a
polling operation.
If you are going to use
Dual Page Scan (p.40),
place the document on
the document glass.
If the address book
screen appears, touch
the [CONDITION
SETTINGS] key to
display the condition
settings screen. (p.7)
The program selection
screen appears.
3
Touch the program key that you wish
to execute. Make sure that the key is
highlighted and then touch the [OK]
key.
OK
R SHARP
ORMAT A
4
Touch the [OK] key.
You will return to the condition settings screen.
5
If needed, select the original size and
other settings, and then press the
[START] key (
Transmission takes place according to the program.
The following settings, which cannot be
Note
stored in a program, can be selected before
pressing the [START] key (
• Original size setting (p.21)
• Two-sided scanning (p.17)
• Job build mode (p.18)
• Timer setting (p.30)
Note that if the dual page function is stored in
the program to be executed, two-sided scanning
and the job build mode cannot be selected.
The program key you
touched is selected and you
return to the screen of step 2.
The [PROGRAM] key
and the keys of the
functions stored in the
program are highlighted.
).
) in step 5.
41
3